How do add a Workspace to the source control?
The documentation says:
Right-click the workspace in the System Tree and select Add to Source Control from the pop-up menu.
BU i have no such entry in my popup
- You are here:
-
Home
-
Q&A
-
Q&A
-
PowerBuilder
- Can not use Source control
-
Ferdinand Fischer
- PowerBuilder
- Thursday, 1 February 2018 22:54 PM UTC
You need to have selected a WORKSPACE in the system tree. Then the PROPERTIES option will be displayed, and from there the next popup will include the SOURCE CONTROL tabpage.
Olan
Comment
- Chris Pollach @Appeon
- Friday, 2 February 2018 14:13 PM UTC
Hi Bruce;
That is an issue when you do not have a consistent GUI interface in PB for SCC handling.
How do you like new approach vs embedding the new GIT/SVN support under the old SCC menus we have known since PB 8?
Regards ... Chris
That is an issue when you do not have a consistent GUI interface in PB for SCC handling.
How do you like new approach vs embedding the new GIT/SVN support under the old SCC menus we have known since PB 8?
Regards ... Chris
- Bruce Armstrong
- Saturday, 3 February 2018 22:34 PM UTC
It's a learning curve, but I'm adjusted. FWIW, it does show up under workspace properties after you've added the workspace to source control. It's just the initial add that takes adjusting to.
There are no comments made yet.
Comment
- Koen de Vos
- Friday, 11 May 2018 10:07 AM UTC
I found the option, it is only available in the 'system tree' and not in the 'Library painter'.
There are no comments made yet.
- Page :
- 1
There are no replies made for this question yet.
However, you are not allowed to reply to this question.
However, you are not allowed to reply to this question.
It's working for me.
If so, I'd open a support case with Appeon. It would appear to be an issue specific to your install.