1. Olan Knight
  2. PowerBuilder
  3. Wednesday, 10 February 2021 21:24 PM UTC


I uninstalled PB2019R2.

I installed PB2019R3.

I migrated my code, and it worked cleanly.

I then got the DLLs out of the bug fix folder 19.2.0.2670_DLL and copied them into my C drive, on top of their respective files. Specifically, the DLLs copied were both the 32 bit and 64 bit versions of:
      PBRibbonBar.dll
      pbtheme.dll
      PBVM.DLL

Then when I attempted to start PBv2019R3 I got this error:



Naturally, the pbsys.dll is nowhere to be found among the installed runtime files.

I reverted to the baseline DLLS and PB started up. The guilty party was PBVM.DLL.

HOWEVER, in the System Tree the Workspaces and targets are no longer displayed.

I uninstalled and reinstalled R3. It made no difference.
Ideleted the pb.ini file. No difference.
I tried VIew / Layours / Default. No difference.

HOW CAN I GET THE SYSTEM TREE BACK TO NORMAL???

Thanks,
Olan

Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Wednesday, 10 February 2021 21:45 PM UTC
  2. PowerBuilder
  3. # 1

Hi Ronnie;

  Did you check in the decoupled run-time folder "c:\Program Files (x86)\appeon\common\powerbuilder\runtime 19.2.0.2670" for the PBSYC.dll? Also note the X64 folder under that if you need the 64bit DLLs as well.   ;-)

Regards ... Chris

Comment
  1. Olan Knight
  2. Wednesday, 10 February 2021 22:04 PM UTC
Thanks for responding so quickly, Chris!

That file was there, but the error msg is asking for pbsyS.dll and I could not find that one anywhere.



Anyway, I gave up on using the bug-fix DLLs and re-installed R3. However, now the SYSTEM TREE is not showing workspaces of targets, and I cannot get a workspace/target to open correctly. How can I restore the system tree?
  1. Helpful
  1. Chris Pollach @Appeon
  2. Wednesday, 10 February 2021 22:29 PM UTC
Sorry Olan .. Yes, not the SYC ASE driver. My Bad!

I do not see any PBSYS.dll for PB2019Rx on my PC's ... only for PB2017R3 (last version - PBSYS170.dll).
  1. Helpful
There are no comments made yet.
Olan Knight Accepted Answer Pending Moderation
  1. Saturday, 10 April 2021 00:17 AM UTC
  2. PowerBuilder
  3. # 2

Solution:    Right-click in the SYSTEM TREE pane and select SET ROOT.

 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.