1. Jon Stoller
  2. PowerBuilder
  3. Wednesday, 28 March 2018 22:56 PM UTC

 Yesterday I asked about an issue where I stopped getting error messages when I make a mistake creating a script.  One reply said to try re-installing.  The other said to see if I resized the window improperly. 

Its not a problem with the window size.  Eventually I will try re-installing the product.  But before I resort to that, does anybody know anything about this problem?  Short of ere-installing PowerBuilder, is there anything else I can do?

Another point I found today.  Today I noticed that when I went into an old window object I did get the error messages.  So now the problem is this -  in some scripts I get error messages but in others I don't. 

Any ideas???

 

Lars Mosegaard Accepted Answer Pending Moderation
  1. Thursday, 29 March 2018 00:21 AM UTC
  2. PowerBuilder
  3. # 1

If all else fails, in no particular order;

  • a full build 
  • optimize libraries
  • view > layouts > (Default)

 

Comment
There are no comments made yet.
Ronnie Po Accepted Answer Pending Moderation
  1. Thursday, 29 March 2018 01:06 AM UTC
  2. PowerBuilder
  3. # 2

Hi Jon,

Are you sure the error panel hasn't been resized down? This has happened to me before, and the symptoms are exactly what you are describing.

See the before and after images below. If you reverse the steps, the panel will re-appear.

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.