1. CJ Lai
  2. PowerServer 2020 or older (Obsolete)
  3. Tuesday, 30 June 2020 19:16 PM UTC

Hi there

I am installing PowerServer 2019 R2 on a Windows Server 2016 as the server's admin.

The installer is telling me that the site I assigned the PowerServer to be installed is not running. but, it is according to the IIS.

I have the application pool, physical path, IP, port, permission user/level all set up.

I was able to install the PowerServer onto this very same server before. This would have been an un-install/re-install, in fact. I had to change the physical path for the site to another drive:\folder

Is there a reason why the Installer is telling me the site isn't ready? What have I missed?

Accepted Answer
CJ Lai Accepted Answer Pending Moderation
  1. Tuesday, 30 June 2020 20:18 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # Permalink

I needed to enable the Directory Browsing before I was able to install the software.

After the successful install, I then disable Directory Browsing.

I don't know if that's proper but that's how I go around it.

Comment
There are no comments made yet.


There are replies in this question but you are not allowed to view the replies from this question.