• You are here:  
  • Home
  • Q&A
  • Q&A
  • PowerBuilder
  • How to install Powerbuilder Runtime Packager after Powerbuilder has been installed.

Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (2)

Resolved How to install Powerbuilder Runtime Packager after Powerbuilder has been installed.

  1. How-to
0
Votes
Undo
  1. Doyle Hagler
    Doyle Hagler
  2. PowerBuilder
  3. Thursday, 13 October 2022 17:11 PM UTC

I am using Powerbuilder 2019 R3 2779.  I want to use the Powerbuilder Runtime Packager, but it appears that it was not installed when I installed Powerbuilder.  I have looked on the website and cannot find where to install it.

Any help on where to find the install for Powerbuilder Runtime Packager?

Thanks

doyle

Ribbon - LargeButton with a menu
Where are my themes?
Responses (2)
Doyle Hagler
Doyle Hagler Accepted Answer Pending Moderation
  1. Thursday, 13 October 2022 19:44 PM UTC
  2. PowerBuilder
  3. # 1

Thanks Chris.  I was looking in the wrong place on my computer.

doyle

Comment
Chris Pollach @Appeon
  1. Chris Pollach @Appeon
  2. Thursday, 13 October 2022 19:57 PM UTC
You are most welcome .. glad that you found it! :-)
  1. Helpful
There are no comments made yet.
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Thursday, 13 October 2022 19:30 PM UTC
  2. PowerBuilder
  3. # 2

Hi Doyle;

   The "Packager" utility is part of any PB IDE installation by default

FYI ...

  1. Launch the PB Help from the PB IDE
  2. Search for the keyword "Packager"
  3. Follow the Help's instructions to locate & start it.

HTH

Regards ... Chris

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.