I'm trying to install the 1880 update for PB, but the installer is telling me it can't determine the version of PB. What is needed for it to move past this.
- You are here:
-
Home
-
Q&A
-
Q&A
-
PowerBuilder
- Trying to install 1880 MR update to PB12
-
jim goodrum
- PowerBuilder
- Thursday, 11 April 2019 17:34 PM UTC
Comment
- Armeen Mazda @Appeon
- Thursday, 11 April 2019 21:08 PM UTC
Based on what Chris said it seems 'PB12' was a typo.
There are no comments made yet.
- Page :
- 1
There are no replies made for this question yet.
However, you are not allowed to reply to this question.
However, you are not allowed to reply to this question.
FYI: Jim opened a Support Ticket for this issue. I advised him to run the update in ADMIN mode and then the MR01 update completed OK.
Regards... Chris