Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (2)

Resolved Powerbuilder R3 install - knocks our Infomaker R1

  1. Issue
0
Votes
Undo
  1. David Vasconcelos
    David Vasconcelos
  2. PowerBuilder
  3. Tuesday, 19 February 2019 18:48 PM UTC

I just upgraded our PB 2017 from R1 to R3 and now Infomaker 2017 does not even run.  Get the following

any ideas how to fix it?  Do I need to re-install Infomaker, since its R1 will it do anything to PB2017 R3 since there are some shared dll's.

 

Note Infomaker was R1 and we were not planning on upgrading to R3 for a while.

 

Uggggg....!

Dave V.

Print Dialog Showing Twice
Powerbuilder 2017 Oracle client 11g connectivity i...
Accepted Answer
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Tuesday, 19 February 2019 20:54 PM UTC
  2. PowerBuilder
  3. # Permalink

Hi Dave;

   InfoMaker is a subset of PowerBuilder. If you have both products installed on the same PC - then, you will also have to download and install the IM2017R3 release as well.

Note: The same for Maintenance Release 01 for R3 as well. It applies to both products on the same PC.

HTH

Regards ... Chris

Comment
There are no comments made yet.
Responses (2)
David Vasconcelos
David Vasconcelos Accepted Answer Pending Moderation
  1. Tuesday, 19 February 2019 22:07 PM UTC
  2. PowerBuilder
  3. # 1

Thanks for the confirmation Chris... kinda thought that but was hoping not.

Dave V.

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.