1. ATK Gimmy Susan
  2. PowerBuilder
  3. Wednesday, 3 October 2018 09:36 AM UTC

Good morning Guru

I'm playing with git and in particular with the branches.
I have a question:
Does Powerbuilder only push and pull on the master branch?

With GitTortoise I can correctly change branches, but any pull and push made by PB do not work.

To have the objects related to the branch I have to do pull / push from gittortoise and then a refresh (if needed).


Correct?

Any contribution is welcome.

Tom Jiang @Appeon Accepted Answer Pending Moderation
  1. Tuesday, 9 October 2018 06:32 AM UTC
  2. PowerBuilder
  3. # 1

Yes, currently PowerBuilder can only push to or pull from the master branch. The development team is working on supporting branching but there is no timeline for that yet.

Regards,

Tom Jiang

Comment
  1. ATK Gimmy Susan
  2. Tuesday, 9 October 2018 08:42 AM UTC
Very sad
  1. Helpful
There are no comments made yet.
ATK Gimmy Susan Accepted Answer Pending Moderation
  1. Saturday, 6 October 2018 16:42 PM UTC
  2. PowerBuilder
  3. # 2

48 view and 0 replay ...... i'm so sad.

any news ? 

 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.