1. CJ Lai
  2. PowerServer 2020 or older (Obsolete)
  3. Friday, 5 June 2020 19:44 PM UTC

Hi

I compiled my application in CloudPro with PowerServer as Web only and configured the setting to run as IWA.

It all worked fine but I just didn't see the desktop icon I was told that would be created for the app.

Please advise.

 

Thanks!

CJ

Accepted Answer
CJ Lai Accepted Answer Pending Moderation
  1. Wednesday, 19 August 2020 20:03 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # Permalink

I had not done anything to address but it showed up. ¯\_(ツ)_/¯

Comment
There are no comments made yet.
CJ Lai Accepted Answer Pending Moderation
  1. Wednesday, 10 June 2020 17:33 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 1

Where can I locate the IWA log?

Thanks!

Comment
There are no comments made yet.
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Friday, 5 June 2020 21:13 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 2

Hi CJ;

  IWA icons are located here in the PS Toolkit's "Application Profile", as follows ...

HTH

Regards ... Chris

Comment
  1. CJ Lai
  2. Monday, 8 June 2020 14:31 PM UTC
Hi Chris

Is there anywhere else I needed to modify?

I did all what you recommended. I loaded a 256x256 ico image. Run as IWA after a full compile and still don't see an icon on my desktop.
  1. Helpful
  1. Chris Pollach @Appeon
  2. Monday, 8 June 2020 21:23 PM UTC
Hi CJ;

FYI: I just retested this feature under the PS2020 release and indeed, the icon is missing from the desktop short-cut after deployment (ie: http://localhost/....../iwarunner.html).

Please open a support ticket for this issue.

Regards ... Chris
  1. Helpful
There are no comments made yet.
Govinda Lopez @Appeon Accepted Answer Pending Moderation
  1. Friday, 5 June 2020 20:47 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 3

Hi CJ,

 

Please modify the settings found in the PowerServer Toolkit.   Select the app you wish to modify and click “Edit”. The select the tab “Runtime Settings”. And the click on “IWA app settings”.

 

After saving the changes, you need to re-deploy your app again. Then click on “Run as IWA”.

Regards,

Attachments (1)
Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.