Hi Libby;

   Have you tried this approach ...  click here?

Regards ... Chris

I ran into the same issue recently:

https://powertothebuilder.com/blogs/2/12/power-builder-sy-sam-issue

​None of the solutions I found helped as is. I had to run as admin to get around it. I hope you have better luck.

PBv12.1 b7055
Windows 7, SP1, 64 bit platform

My account is an administrator on my VM.

My entire VM was recently moved from one server to another in a different city.

I ahd to do the following:

1) Uninstall SYSAM
2) Re-install SYSAM v2.2 from the PBv12.6 install disks
3) Go to the SAP Launchpad website and generate a new License Key
4) Open LMTOOLS.exe and set the LMGRD.EXE selection to the lmgrd,exe file within the IPV6 folder
5) Download the new license to the SysM Licenses folder
6) Reboot.

That got SYSAM working.
Now you open PB, wait for it to say NOT VALIDATED, close PB, and open PB again.
That got PB working.


Good Luck,

Olan

 

PBv12.1 b7055
Windows 7, SP1, 64 bit platform

My account is an administrator on my VM.

My entire VM was recently moved from one server to another in a different city.

I had to do the following:

1) Uninstall SYSAM
2) Re-install SYSAM v2.2 from the PBv12.6 install disks
3) Go to the SAP Launchpad website and generate a new License Key
4) Open LMTOOLS.exe and set the LMGRD.EXE selection to the lmgrd,exe file within the IPV6 folder
5) Download the new license to the SysM Licenses folder
6) Reboot.

That got SYSAM working.
Now you open PB, wait for it to say NOT VALIDATED, close PB, and open PB again.
That got PB working.


Good Luck,

Olan

 

Hi, In the past I had this error, --------------------------- License Initialization --------------------------- Failed to initialize SySAM licensing. PowerBuilder is shutting down. A mandatory property is missing. To help diagnose the problem, you can enable logging by adding the following to the PB.INI file: [pb] LogSySAM=1 The log file is 'pb115_sysam.log'. --------------------------- Aceptar --------------------------- Solution Your pb115_sysam.properties file (in C:\Users\xxxx\AppData\Local\Sybase\PowerBuilder 11.5) seems corrupted... Try to replace it with the one from C:\Program Files (x86)\Sybase\PowerBuilder 11.5 I hope this can help you Regards

Thanks for all of the responses.  I didn't try all of the suggestions, but we ended up upgrading to PB 2017 and this solved the problem.