• You are here:  
  • Home
  • Q&A
  • Q&A
  • PowerBuilder
  • Authoritation with Webbrowser Control isn't working

Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (1)

Resolved Authoritation with Webbrowser Control isn't working

  1. Issue
0
Votes
Undo
  1. Sandra Steil
    Sandra Steil
  2. PowerBuilder
  3. Tuesday, 15 June 2021 09:38 AM UTC

Dear Community,

I’m working with the PowerBuilder R3 Build 2703 and I want to navigate to an signin page with ntlm-Authentication via WebBrowserControl.
After input and confirmation the credentials it shows the popup for the authentication again and don’t show me an error.
I tried three methods of auth (Base, NTLM and Negotiate) and i get always this popup and not an error.

A Request via HttpClient with the same credentials works.

Is it possible to customize the header from the browsercontrol that i can send the credentials with the sending the URL from the page.

Powerclient issues
Timing Problem with initialisation of Visual User ...
Responses (1)
René Ullrich
René Ullrich Accepted Answer Pending Moderation
  1. Tuesday, 15 June 2021 11:33 AM UTC
  2. PowerBuilder
  3. # 1

Hi Sandra,

AFASIK you can currently not specify authentication credentials by script for webbrowser control. 

Regards,

René

Comment
Sandra Steil
  1. Sandra Steil
  2. Tuesday, 15 June 2021 12:09 PM UTC
I need an example for these control who works with an NTLM-Authentication.

I want to define the credentials in the script that the user don't type the credetials manually in the Webbrowsercontrol
  1. Helpful
René Ullrich
  1. René Ullrich
  2. Tuesday, 15 June 2021 12:13 PM UTC
You can't do that with the current webbrowser control!
  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.