1. william yau
  2. InfoMaker
  3. Monday, 19 July 2021 10:07 AM UTC

Hi guru

I upgraded powerbuilder 7.0 to 2019 R3 . is need  to upgrade my 7.0 PSR ,

if need to upgrade. is need to infomake to upgrade or other method

 

please advise

 

William

 

 

Accepted Answer
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Monday, 19 July 2021 16:25 PM UTC
  2. InfoMaker
  3. # Permalink

Hi William;

  Yes, there is a matching IM 2019 R3 as well. If you are producing PSR's that are used between PB & IM then A) You need to make sure that your have PB & IM 2019 R3 installed: A) on the developer's PC; B) IM2019R3 is required to be used when App EXE's are compiled from PB2019R3 and C) PB / IM 7.x PSR's should no longer be used with PB 2019 R3 App's or IM 2019 R3 users.

HTH

Regards ... Chris

Comment
There are no comments made yet.
william yau Accepted Answer Pending Moderation
  1. Wednesday, 21 July 2021 04:18 AM UTC
  2. InfoMaker
  3. # 1

Chris

 

thank for your help, problem solved 

 

 

William 

Comment
  1. Chris Pollach @Appeon
  2. Wednesday, 21 July 2021 13:24 PM UTC
That is great news .. thanks for the feedback William!
  1. Helpful
There are no comments made yet.
william yau Accepted Answer Pending Moderation
  1. Tuesday, 20 July 2021 03:10 AM UTC
  2. InfoMaker
  3. # 2

Chris

 

Would you know how to migration PSR using infomaker or give me some reference 

 

William

Comment
  1. Chris Pollach @Appeon
  2. Tuesday, 20 July 2021 15:30 PM UTC
Hi William;



This seems like a simple task ... say read the PSR into a DW Control and then use the SaveAs() to write it back to disk. Unfortunately, the PSR contains the DWO source as well as data. So just reading the PSR will not change the DWO source - which is still in PB 7.x format.



The proper way forward would be to check each migrated DWO in PB2019R3 (edit source) PBL(s) that interact as a PSR and make sure that the "Release=" attribute is set to "19". That will complete the last piece of the DWO syntax source code migration ( TIP: You can write a small PB App utility to do that in an automated fashion). Then you need to rebuild the PSR's from the new properly migrated DWO source that now includes the migrated DWO source and data in PB2019R3 format.



If it a historical issue, I would just write a small PB App utility that reads the PB v7.x PSR into a DW Control and then have the utility save the result as a PDF using the SaveAs (PDF!) command.



HTH

Regards ... Chris
  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.