Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (2)

Resolved SYSTEM TREE no longer shows workspace or targets

  1. How-to
0
Votes
Undo
  1. Olan Knight
    Olan Knight
  2. PowerBuilder
  3. Wednesday, 10 February 2021 21:24 PM UTC


I uninstalled PB2019R2.

I installed PB2019R3.

I migrated my code, and it worked cleanly.

I then got the DLLs out of the bug fix folder 19.2.0.2670_DLL and copied them into my C drive, on top of their respective files. Specifically, the DLLs copied were both the 32 bit and 64 bit versions of:
      PBRibbonBar.dll
      pbtheme.dll
      PBVM.DLL

Then when I attempted to start PBv2019R3 I got this error:



Naturally, the pbsys.dll is nowhere to be found among the installed runtime files.

I reverted to the baseline DLLS and PB started up. The guilty party was PBVM.DLL.

HOWEVER, in the System Tree the Workspaces and targets are no longer displayed.

I uninstalled and reinstalled R3. It made no difference.
Ideleted the pb.ini file. No difference.
I tried VIew / Layours / Default. No difference.

HOW CAN I GET THE SYSTEM TREE BACK TO NORMAL???

Thanks,
Olan

How can I get my SYSTEM TREE restored?
How to get mail messages via SMTP in PB2019?
Responses (2)
Olan Knight
Olan Knight Accepted Answer Pending Moderation
  1. Saturday, 10 April 2021 00:17 AM UTC
  2. PowerBuilder
  3. # 1

Solution:    Right-click in the SYSTEM TREE pane and select SET ROOT.

 

Comment
There are no comments made yet.
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Wednesday, 10 February 2021 21:45 PM UTC
  2. PowerBuilder
  3. # 2

Hi Ronnie;

  Did you check in the decoupled run-time folder "c:\Program Files (x86)\appeon\common\powerbuilder\runtime 19.2.0.2670" for the PBSYC.dll? Also note the X64 folder under that if you need the 64bit DLLs as well.   ;-)

Regards ... Chris

Comment
Olan Knight
  1. Olan Knight
  2. Wednesday, 10 February 2021 22:04 PM UTC
Thanks for responding so quickly, Chris!

That file was there, but the error msg is asking for pbsyS.dll and I could not find that one anywhere.



Anyway, I gave up on using the bug-fix DLLs and re-installed R3. However, now the SYSTEM TREE is not showing workspaces of targets, and I cannot get a workspace/target to open correctly. How can I restore the system tree?
  1. Helpful
Chris Pollach @Appeon
  1. Chris Pollach @Appeon
  2. Wednesday, 10 February 2021 22:29 PM UTC
Sorry Olan .. Yes, not the SYC ASE driver. My Bad!

I do not see any PBSYS.dll for PB2019Rx on my PC's ... only for PB2017R3 (last version - PBSYS170.dll).
  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.