Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (3)

Resolved Unstable IDE

  1. Issue
0
Votes
Undo
  1. Michael Connell
    Michael Connell
  2. PowerBuilder
  3. Friday, 14 August 2020 11:07 AM UTC

I'm having a problem with the PowerBuilder IDE. If I open PB and run the selected target (of 2 targets) in the local workspace, the application starts and runs OK.

But if I close the application and then right click the other target (with the intention of setting this as current) the IDE simply terminates without an error.

The IDE also abnormally terminates (again without an error) if I try to run either target in debug mode, with or without a breakpoint.

Has anyone else experienced this behaviour and have you found a solution?

Ought perhaps to add that we're using PB 2017 R3 build 1858

  1. Crash
  2. IDE
Deployment of 2019 R2 Applications into same direc...
Datawindow Control Name/Tag
Responses (3)
Olan Knight
Olan Knight Accepted Answer Pending Moderation
  1. Friday, 14 August 2020 18:42 PM UTC
  2. PowerBuilder
  3. # 1

Adding to what Chris said:

5. Do a FULL BUILD on the 2nd app, then do a FULL BUILD on the 1st app.

6.  Try again with two app under the workspace in the IDE.


Olan

Comment
There are no comments made yet.
Govinda Lopez @Appeon
Govinda Lopez @Appeon Accepted Answer Pending Moderation
  1. Friday, 14 August 2020 16:59 PM UTC
  2. PowerBuilder
  3. # 2

Hi Michael,

 

Adding to what Chris said, please make sure that all your files have the correct read/write permissions set on them. And that PB has the correct execution permissions too.

 

 

Regards,

Comment
There are no comments made yet.
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Friday, 14 August 2020 16:13 PM UTC
  2. PowerBuilder
  3. # 3

Hi Michael;

   Sounds like the 2nd Target file might be corrupt. My suggestion would be to

1) Close the PB IDE

2) Delete the 2nd Target file (a .PBT)

3) Restart the IDE and let it update the Workspace that the 2nd target is now gone.

4) Add the 2nd Target back via the PB IDE

HTH

Regards ... Chris

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.