Hi all,

I was doing some experiment with PowerBuilder 2021 and WebView2 controller hosted in .Net.

I used the basic and simplest setup in .Net. Basically, just opening a static webpage.

I placed a WebBrowser controller on one side and a WebView2 controller on the other side for comparison and better visualized understanding.

Then I made the PowerBuilder to launch the window.

As can be seen from the image below. PowerBuilder opens the window but only the WebBrowser controller is displayed (left side).

The right side, which contains the WebView2 controller remains empty.

Note that debug did not show any exceptions, errors or warnings while loading. In fact, this window displayed properly on both sides, when launching it from the .Net itself.

I was wondering. What is the support stage of WebView2 controller in the PowerBuilder 2021?

Any advise to make WebView2 controller operable (displayed) is appreciated.

Thank you