Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (2)

Resolved Icon File in PNG format

  1. Issue
0
Votes
Undo
  1. James Raw
    James Raw
  2. PowerBuilder
  3. Monday, 2 September 2024 08:47 AM UTC

Just migrated to use the latest PowerBuilder.

Built using PBAutoBuild, when i run the software, at startup i get the following error:
---------------------------
Error
---------------------------
You have specified an icon file in PNG format, which is unsupported. Please specify an icon file in BMP format.
---------------------------
OK
---------------------------

I have no idea where or why the error is occurring.

If i run the application under the Powerbuilder ide, then i don't get the issue.

Orcascr220 error -22 help
Conversion of powerbuilder 2022 from 32-bit to 64-...
Responses (2)
James Raw
James Raw Accepted Answer Pending Moderation
  1. Monday, 2 September 2024 12:28 PM UTC
  2. PowerBuilder
  3. # 1

I did read somewhere in the help file that png based icons aren't supported, but it doesn't explain why its fine under the PowerBuilder IDE.

I will create a support ticket.

Comment
There are no comments made yet.
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Monday, 2 September 2024 12:16 PM UTC
  2. PowerBuilder
  3. # 2

Hi James;

 Please open a support ticket for this issue for a deeper look into this problem.

Regards ... Chris 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.