1. James Raw
  2. PowerBuilder
  3. Monday, 2 September 2024 08:47 AM UTC

Just migrated to use the latest PowerBuilder.

Built using PBAutoBuild, when i run the software, at startup i get the following error:
---------------------------
Error
---------------------------
You have specified an icon file in PNG format, which is unsupported. Please specify an icon file in BMP format.
---------------------------
OK
---------------------------

I have no idea where or why the error is occurring.

If i run the application under the Powerbuilder ide, then i don't get the issue.

James Raw Accepted Answer Pending Moderation
  1. Monday, 2 September 2024 12:28 PM UTC
  2. PowerBuilder
  3. # 1

I did read somewhere in the help file that png based icons aren't supported, but it doesn't explain why its fine under the PowerBuilder IDE.

I will create a support ticket.

Comment
There are no comments made yet.
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Monday, 2 September 2024 12:16 PM UTC
  2. PowerBuilder
  3. # 2

Hi James;

 Please open a support ticket for this issue for a deeper look into this problem.

Regards ... Chris 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.