Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (2)

Resolved Where is "Add to Source Control" ?

  1. How-to
0
Votes
Undo
  1. Mihai Apostol
    Mihai Apostol
  2. PowerBuilder
  3. Monday, 5 July 2021 21:11 PM UTC

Hi all,

 

I'm using PB2019 r3 build 2703. 

I would like to add my Workspace to Git but the option "Add to Source Control" on the right-click on the workspace is not there. Is there any additional configuration that I should make? 

Thank you, 

Mihai

 

Time Zone problem when using Today()
How to install both Powerbuider 2019 R2 and R3 on ...
Responses (2)
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Tuesday, 6 July 2021 01:26 AM UTC
  2. PowerBuilder
  3. # 1

Hi Mihai;

  If you check the "About" dialogue ... are you using the Standard, Professional or CloudPro edition?

Normally, you would see this option right off the WorkSpace via the RMB, as follows:

HTH

Regards ... Chris

Comment
Mihai Apostol
  1. Mihai Apostol
  2. Tuesday, 6 July 2021 02:11 AM UTC
Hi Chris,



I have the Standart edition. Should I switch to Professional in order to display the option? How I can do it?

Thank you!
  1. Helpful
Chris Pollach @Appeon
  1. Chris Pollach @Appeon
  2. Tuesday, 6 July 2021 14:11 PM UTC
Hi Mihai;

That feature should be in the Standard edition as well. It could be possible that you did *not* perform a "full" installation with your PB2019 R3. Please try reinstalling with all features checked in the Appeon Installer. Also FWIW: I would also recommend installing the 1st maintenance release as well (MR01 build 2703) as it addresses a few GA nuances.

HTH

Regards ... Chris
  1. Helpful
There are no comments made yet.
Tom Jiang @Appeon
Tom Jiang @Appeon Accepted Answer Pending Moderation
  1. Tuesday, 6 July 2021 10:40 AM UTC
  2. PowerBuilder
  3. # 2

Hi Mihai,

When you installed PowerBuilder, did you use the default options or did you choose not to install some components, especially the SCC interface? You can double verify by checking if you have the PBSourceControl.dll file in "C:\Program Files (x86)\Appeon\PowerBuilder 19.0\IDE".

I suggest that you re-install PowerBuilder with all component and see if it resolves the issue.

Regards,

Tom Jiang

 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.