2. SnapDevelop
  3. Saturday, 11 April 2020 09:19 AM UTC


I'm trying to connect on my local SQL server using SnapDevelop while adding data context but every time I get the same error as below 



As I tried through SSMS and its working fine and I tried with Powerbuilder Database connection and also it's working fine there too.


Please suggest any solutions asap.






Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Saturday, 11 April 2020 14:50 PM UTC
  2. SnapDevelop
  3. # 1

Hi Harshit;

   If your using SS "Express" edition, please make sure that TCP/IP protocol is turned on. Normally, the SSE instantation does not enable this. Both PB, PS and Snap require this protocol in order to communicate to SS.


Regards ... Chris

There are no comments made yet.
  • Page :
  • 1

There are no replies made for this question yet.
However, you are not allowed to reply to this question.