1. Mark Lundell
  2. PowerServer 2020 or older (Obsolete)
  3. Thursday, 19 March 2020 15:56 PM UTC

I have a treeview in powerserver which is is leaving space for a picture when there are no pictures and  PictureWidth = 0.  Am I missing something?

Attachments (1)
Accepted Answer
Mark Lundell Accepted Answer Pending Moderation
  1. Monday, 23 March 2020 20:12 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # Permalink

A team member found an answer for this.  I have no pictures for the treeview because I only wanted the lines.  If I set the picturewidth = 0 it leaves space for the pictures.  If I comment out the PictureWidth = 0 it works as desired.

Comment
There are no comments made yet.
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Thursday, 19 March 2020 16:43 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 1

Hi Mark;

   This was done by Sybase by design way back this feature was 1st released. So the short answer becomes .. "always" have an image assigned for all possible states.

Regards ... Chris

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.