1. Joo Hwan An
  2. PowerBuilder
  3. Thursday, 21 December 2017 00:24 AM UTC
Window type is developed using mdidockhelp! from the Power Builder 2017.
There are several problems.
1.Open the window and press the Shortcut key to operate it.
But
After closing the window, the shortcut will not operate since it has been closed.
It won't work if you close it once regardless of any windows.
2.If the mouse pointer is positioned above the Windows tab area, the shortcut key is not working.
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Thursday, 21 December 2017 14:15 PM UTC
  2. PowerBuilder
  3. # 1

Hi Joo Hwan;

     If the short-cut key is being handled by the menu attached to the frame, then your scenario would be the case as the current menu is not designed to intercept that key sequence. Closing the current window open in the frame reverts the menu either back to another active sheet for the frame where the short-cut key sequence is known.

    The other scenario is that another window is designed to intercept the KEY event whereas the current window is not. Closing the current window reset's the window focus back to an instance that does handle the key event. Either way, I suspect that these possible scenarios would also be the case in PB 12.6.

HTH

Regards ... Chris

Comment
  1. Joo Hwan An
  2. Tuesday, 26 December 2017 05:13 AM UTC
Thank you for your answer.

Let's review what you answered and see if we can check it again.

Prior to that, in a demo folder (PB12.6 CodeExamples) with the environment that we tested, we had only set up a shortcut without modification to the MDIDockingDemo source.

If you have time, please check ' MDIDockingDemo '.

  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.