1. Andres Slachevsky
  2. PowerServer 2020 or older (Obsolete)
  3. Wednesday, 27 June 2018 14:01 PM UTC

Hello All,

I have a Crossatab DW 

running in PowerServer  when the width of the dW use only one page it works with no problem

when it use more than 1 page of width it dysplay only the information in the first page.

 

Andres Slachevsky Accepted Answer Pending Moderation
  1. Thursday, 28 June 2018 12:21 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 1

we found out the following:
The crosstab is in a Nested report.

If we add a line that fit the width of the Crosstab it works.

Comment
There are no comments made yet.
Alfredo Aldama Accepted Answer Pending Moderation
  1. Wednesday, 27 June 2018 19:43 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 2
Hi. The workaround change type page... If you need show more columns, you check in mode datawindow preview Regards
Comment
  1. Andres Slachevsky
  2. Thursday, 28 June 2018 11:53 AM UTC
It's not a valid solution 



cause the report must be printed.



if we add a line that change the size to fit all the width of the Crosstab if solve the issue

  1. Helpful
There are no comments made yet.
Marco Meoni Accepted Answer Pending Moderation
  1. Wednesday, 27 June 2018 19:32 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 3

Hello Andres,

crosstab printout looks fine on my side.

Did you specify any custom page size that may prevent printing the 2nd page?
Does the crosstab print fine in PB?

Best,

.m

Comment
  1. Andres Slachevsky
  2. Thursday, 28 June 2018 11:54 AM UTC
Hello Marco.



Yes we test changed the size so it fits in one page



the DW works perfect in PB



cause the report must be printed.



also if we add a line that change the size to fit all the width of the Crosstab if solve the issue



 

  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.