1. Daniel Gonzalez
  2. PowerServer 2020 or older (Obsolete)
  3. Friday, 11 September 2020 12:29 PM UTC

Good morning, how to configure the PowerServer Local to generate a web application?
When I'm going to generate it, it gives this error message attached.

Thank you

 

Attachments (1)
Armeen Mazda @Appeon Accepted Answer Pending Moderation
  1. Friday, 11 September 2020 14:40 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 1

Did you install PowerServer in addition to the PowerServer Toolkit?

When you type http://localhost/AEM in a Web browser are you able to see the PowerServer admin page?

 

 

Comment
There are no comments made yet.
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Friday, 11 September 2020 14:13 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 2

Hi Daniel;

   This is a message from the "PS Toolkit" application that has been installed in your PB IDE's work area. The toolkit is trying to connect to your DBMS to check the PB App's SQL syntax. So you need to configure the PS Toolkit's DB connection information in order for the compiler to be able to validate your PB App's SQL as it parses & converts your PowerScript to jScript. You can select the "Configure" icon on the lower PS Toolkit's toolbar and from there, configure the DB connection(s) you need.

  Once the DB connections are configured in your PS Toolkit, then you can associate and use them in your "Application Profiles" to allow the toolkit to actually deploy your PB native App as either a Web or Mobile App to PowerServer itself.

HTH

Regards ... Chris

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.