Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (1)

Resolved powerbuilder 7.0

  1. New
  2. How-to
0
Votes
Undo
  1. william yau
    william yau
  2. PowerBuilder
  3. Tuesday, 10 December 2024 03:50 AM UTC

"For PowerBuilder 7.0, if the tab order is equal to 0, how can I assign a value to it in the DataWindow?"

By the way, if my table column is of type ntext, can I use this column to create a checkbox? If I cannot use this column for a checkbox, how can I create one

William

 

Unknown control mdirbb_1 error
Advice related to character encoding - CharSet
Responses (1)
Sivaprakash BKR
Sivaprakash BKR Accepted Answer Pending Moderation
  1. Tuesday, 10 December 2024 05:08 AM UTC
  2. PowerBuilder
  3. # 1

1.  SetTabOrder is the command that we use to set tab order value for PB 10.5 later.   I have no idea about PB 7.0
2.  Have one hidden checkbox column.  Make it visible on particular condition(s) and assign the value to the required column before updating the datawindow.

HTH

Happiness always
BKR Sivaprakash

 

Comment
Andreas Mykonios
  1. Andreas Mykonios
  2. Tuesday, 10 December 2024 09:32 AM UTC
Well, settaborder existed before PowerBuilder 7, so it should work...

Andreas.
  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.