1. TOMAZ KRALJ
  2. PowerBuilder
  3. Thursday, 21 October 2021 15:44 PM UTC

Hello,

 

I tried to install PB 2021 .

During installation I got error:

Installation finished sussessfully:

 

After restart of PC, I tried to rum PB IDE and got this error:

 

What could be problem of my installation?

 

Regards

Tomaž

 

 

 

 

 

Accepted Answer
Aubrey Lin @Appeon Accepted Answer Pending Moderation
  1. Friday, 22 October 2021 08:48 AM UTC
  2. PowerBuilder
  3. # Permalink

Hi Tomaz,

 

It looks like this file was not installed because the corresponding component was canceled. Did you deselect some components during the installation?

Please uninstall, then install again and in the meantime make sure SCC Interface is selected for installation.

 

Regards,

Aubrey

Comment
  1. TOMAZ KRALJ
  2. Friday, 22 October 2021 09:40 AM UTC
Thank you Aubrey,

yes SCC Interface was not selected, when I selected also this component, installation was successfully finished and PB is running. Is this bug in installation process?

Regards

Tomaž
  1. Helpful
  1. Chris Pollach @Appeon
  2. Friday, 22 October 2021 19:03 PM UTC
Good catch Aubrey! :-)
  1. Helpful
  1. Aubrey Lin @Appeon
  2. Tuesday, 26 October 2021 08:07 AM UTC
Hi Tomaz,



SCC Interface should be an optional components, not a must-install one as it's for source control and only required when user needs to use SVN or Git. So yes, it's bug that it reports this PBSourceControl.dll does not exits.
  1. Helpful
There are no comments made yet.
TOMAZ KRALJ Accepted Answer Pending Moderation
  1. Friday, 22 October 2021 06:24 AM UTC
  2. PowerBuilder
  3. # 1

Hello Chris,

 

I already used offline installer, but after your response, I downloaded again last version, which was the same. 

I made installation with admin rights and result is completely the same as on my first installation. 

Pbnat.dll which was not registered is not even present on my computer, why?

I have also installed PB 2019 R2 which is working ok.

Any help appreciated.

 

Tomaž  

Comment
There are no comments made yet.
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Thursday, 21 October 2021 16:05 PM UTC
  2. PowerBuilder
  3. # 2

Hi Tomasz;

  I would suggest performing an offline install by requesting the Appeon Installer to download the Install "Packages" first. Then run the PB/PS 2021 install via their associated packages and running these as "Admin".

Regards ... Chris

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.