1. Maria Adiela Tabares Marin
  2. PowerBuilder
  3. Wednesday, 13 November 2019 20:09 PM UTC

Hello

I need help please in the following

In the version of Power Builder 2017 when I change the default printer, having a pb2017 application running. And I send to print, I have to close the cb transfer and reopen it so that I can take the printer that I just placed as default.

That did not happen in the previous versions of pb. Please help me how to solve this since it is causing us inconveniences in the operations with the clients.

Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Wednesday, 13 November 2019 21:33 PM UTC
  2. PowerBuilder
  3. # 1

Hi Maria;

   Have a look at the "PrintGetPrinter", "PrintGetPrinters", "PrintSetPrinter", etc built-in PowerBuilder commands for that task.

HTH
Regards ... Chris

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.