1. Mikhael Botvinik
  2. PowerBuilder
  3. Sunday, 7 June 2020 15:09 PM UTC

We are using PowerBuilder 12.5 with Team Foundation Server MSSCCI provider as source control. Now we installed the Team Foundation Server on another server computer. In Team Explorer I added the new location, but in PowerBuilder still see the old( for example, when try to check out). How/where to change definition of server side root($) location in PowerBuilder?  


Accepted Answer
Miguel Leeuwe Accepted Answer Pending Moderation
  1. Monday, 8 June 2020 10:46 AM UTC
  2. PowerBuilder
  3. # Permalink


I remember having suffered the same problem after moving to another server. If I remember well I searched everywhere in the registry to see if I could find the old connect with TFS and replace it with the new one, but I vaguely remember that that did not work.

Have you tried to use this option?

It will open up team explorer. From there switch to your new TFS server and cross fingers it stays recorded that way.



There are no comments made yet.
Mikhael Botvinik Accepted Answer Pending Moderation
  1. Monday, 8 June 2020 10:58 AM UTC
  2. PowerBuilder
  3. # 1

Thank You.

I already edited the registry and I think that it worked fine. 

  1. Miguel Leeuwe
  2. Monday, 8 June 2020 11:05 AM UTC
  1. Helpful
There are no comments made yet.
  • Page :
  • 1

There are no replies made for this question yet.
However, you are not allowed to reply to this question.