1. mike S
  2. PowerServer
  3. Tuesday, 13 September 2022 17:46 PM UTC

If i use a commandparm to start powerserver client app, it will be forever sent as a commandparm.

what is going on?  how do you get rid of the commandline parm?


poweserver help has zero information if you search on commandparm

Tracy Huang @Appeon Accepted Answer Pending Moderation
  1. Wednesday, 14 September 2022 03:31 AM UTC
  2. PowerServer
  3. # 1

Hi Mike,

Thank you for sharing your findings. I will incorporate the following article into the user documents.




There are no comments made yet.
mike S Accepted Answer Pending Moderation
  1. Tuesday, 13 September 2022 17:57 PM UTC
  2. PowerServer
  3. # 2

OK, poked around looking for undocumented files, and found pbapp.ini.


it has: 

startParam=https://myurl/myapp/ AppCommand AppCommand?f


this needs to be documented since it is important to how PS runs.


Also, how it works doesn't make any sense based on what i am seeing.




There are no comments made yet.
  • Page :
  • 1

There are no replies made for this question yet.
However, you are not allowed to reply to this question.