1. William Nevins
  2. PowerServer
  3. Friday, 25 June 2021 19:42 PM UTC

Just finished upgrading my PowerServer to 2020 along with MR2703.  When I clicked on my IWA runner icon, it asked me to upgrade then I get

Followed by

followed by

and then

Everything looks ok in AEM.

Did I miss something in the upgrade?

Thanks

 

 

Kai Zhao @Appeon Accepted Answer Pending Moderation
  1. Saturday, 26 June 2021 00:41 AM UTC
  2. PowerServer
  3. # 1

Hi William,

Please go to AEM > Application > Transactions > Transaction Objects > [your application] and make sure you had setup transaction object to data source mapping, please refer to article below for more detail.
https://docs.appeon.com/ps2020/server_configuration_guide_for_net/Transactions.html#d0e6979

Regards,
ZhaoKai

Comment
There are no comments made yet.
William Nevins Accepted Answer Pending Moderation
  1. Monday, 28 June 2021 13:00 PM UTC
  2. PowerServer
  3. # 2

Hello ZhaoKai,

 

My AEM appears to be setup correctly

 

Comment
There are no comments made yet.
mike S Accepted Answer Pending Moderation
  1. Monday, 28 June 2021 14:22 PM UTC
  2. PowerServer
  3. # 3

Did you setup the data source?

it is setup under: Server - Resources - Data Source

 

 

Comment
  1. William Nevins
  2. Monday, 28 June 2021 16:12 PM UTC
Yes, data source is setup. Thanks
  1. Helpful
There are no comments made yet.
Armeen Mazda @Appeon Accepted Answer Pending Moderation
  1. Monday, 28 June 2021 15:35 PM UTC
  2. PowerServer
  3. # 4

After upgrading, did you do a full redeploy (not incremental) of your app so it regenerates the app files based on the new version/build?

Comment
  1. William Nevins
  2. Monday, 28 June 2021 16:11 PM UTC
Hi Armeen,



Yes, I did a full deployment. I ran the Powerserver 2020 upgrade, did the Maintenance release. I'm using PB 2019 R3. AEM shows Data Source and SQLCA transanction object connected.



Thanks
  1. Helpful
  1. Armeen Mazda @Appeon
  2. Monday, 28 June 2021 17:22 PM UTC
I don't see any obvious mistake you made. I think next step should be to open a support ticket: https://www.appeon.com/standardsupport/newbug
  1. Helpful
There are no comments made yet.
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Monday, 28 June 2021 20:16 PM UTC
  2. PowerServer
  3. # 5

Hi William;

  Please check your PS Server Logs via AEM. That might give you a lot more detail on what the App issue(s) might truly be. Also, try running the App(s) as a WEB app via their HTTP URLs and see if they work that way before going the AWS route.

  I am also assuming that that your PS is running on a local IIS to your PB IDE (which might need to be run in ADMIN mode for deploying 100%).

  Failing that, I would recommend opening a Support Ticket.

 HTH
Regards ... Chris

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.