1. Haihong Yang
  2. PowerBuilder
  3. Tuesday, 27 April 2021 19:25 PM UTC

Hi,
We want to switch powerbuilder source control from TFS to git using azure devops. We are using PB 2019 R3. I can push the PB code from local repository to remote Azure devops. But when I try to get the code from remote repository using "Connect to workspace" in IDE, I get error says cannot find workspace file. An empty local repository created by IDE. I am wondering how can I solve this problem. I can use third party tool to download code from devops. But is this the right way? If there are multiple branches in the remote repository, PowerBuilder IDE can not specify which branch to download. I am wondering if PowerBuilder can directly work with azure devops.

 

Regards    

Scott Westfall Accepted Answer Pending Moderation
  1. Friday, 16 September 2022 13:59 PM UTC
  2. PowerBuilder
  3. # 1

Hi Mark,

 

Any luck with this issue? My IT department is going through the same issue now...especially since TLS1.1 (VS 2013 protocol) is no longer working.

Comment
There are no comments made yet.
Mark Calder Accepted Answer Pending Moderation
  1. Thursday, 28 April 2022 18:01 PM UTC
  2. PowerBuilder
  3. # 2

Same problem, one year later....  The silence is not encouraging.

Comment
  1. Olan Knight
  2. Friday, 16 September 2022 21:39 PM UTC
I thought that TLS1.1 was no longer supported.

Am I wrong?
  1. Helpful
  1. Chris Pollach @Appeon
  2. Friday, 16 September 2022 21:56 PM UTC
Hi Olan;

It's still supported but most IT shops have either removed or disabled it because of security concerns.

Regards ... Chris
  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.