1. Kevin Bey
  2. PowerBuilder
  3. Monday, 15 October 2018 14:11 PM UTC

Can you tell me if Powerbuilder pfc 6.0 is compatible with 2017 R3?  

Thank you

Shenn Sellers Accepted Answer Pending Moderation
  1. Monday, 15 October 2018 16:04 PM UTC
  2. PowerBuilder
  3. # 1

I would say no.  You really should be using the matching PFC version to the PB version.

Comment
There are no comments made yet.
John Fauss Accepted Answer Pending Moderation
  1. Monday, 15 October 2018 16:21 PM UTC
  2. PowerBuilder
  3. # 2
I also recommend you use the latest version of the PFC with PB 2017, especially since you are migrating from version 6. There were several changes to the PFC when PB switched to Unicode in version 10. There were also some changes reflecting the drop of support for alternative platforms (such as Solaris, for example). The PFC no longer uses a DLL for common dialog windows as it did back in the PB 5 & 6 & 6.5 days. You will likely have a difficult time making the needed changes to the PFC-layer objects yourself. There have been some new contributions to the PFC in the last few branches as well.
Comment
There are no comments made yet.
Roland Smith Accepted Answer Pending Moderation
  1. Monday, 15 October 2018 21:00 PM UTC
  2. PowerBuilder
  3. # 3

Also PFC 6 has objects for Distributed PB which no longer exists.

Comment
There are no comments made yet.
Roland Smith Accepted Answer Pending Moderation
  1. Monday, 15 October 2018 21:01 PM UTC
  2. PowerBuilder
  3. # 4
Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.