Subscribe via RSS
Toggle Submenu
  1. Categories
  2. Recent
  3. Tags
View Replies (3)

Resolved PB 2021 and 2019 R3: Reopen workspace on startup.

  1. How-to
0
Votes
Undo
  1. Andreas Mykonios
    Andreas Mykonios
  2. Beta Testing
  3. Friday, 30 April 2021 09:54 AM UTC

Testing PB 2021 Beta.

I noticed that after closing PB 2021, if I launch PB 2019 R3 it attempts to load the most recent workspace that I used in PB 2021. If I select a different one, and then if I close PB 2019 R3 and launch PB 2021 it attempts to load the one I opened in PB 2019 R3. So it seems like IDE's are using a common place to store that information. Has anyone else noticed that behavior?

Andreas.

PB 2019 Beta - Runtime
PB 2021 what's new in PowerBuilder except for the ...
Responses (3)
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Friday, 30 April 2021 14:31 PM UTC
  2. Beta Testing
  3. # 1

Hi Andres;

  FYI:  I am not getting this issue.

Regards ... Chris

Comment
There are no comments made yet.
Andreas Mykonios
Andreas Mykonios Accepted Answer Pending Moderation
  1. Friday, 30 April 2021 15:06 PM UTC
  2. Beta Testing
  3. # 2

I see that this setting is stored in C:\Users\Majg\AppData\Local\Appeon\PowerBuilder 19.0\pb.ini, and in C:\Users\Majg\AppData\Local\Appeon\PowerBuilder 21.0\pb.ini. I don't know why, both IDE seem to try to open the last workspace used in any of them. I have the following setting enabled:

Andreas.

Comment
Chris Pollach @Appeon
  1. Chris Pollach @Appeon
  2. Friday, 30 April 2021 15:19 PM UTC
Poltergeists maybe .. LOL?
  1. Helpful
There are no comments made yet.
Chris Pollach @Appeon
Chris Pollach @Appeon Accepted Answer Pending Moderation
  1. Friday, 30 April 2021 15:28 PM UTC
  2. Beta Testing
  3. # 3

Hi Andreas;

  No such issues for me from the PB2021 IDE to opening and building a PB2019R3 workspace ...

Regards ... Chris

Comment
Andreas Mykonios
  1. Andreas Mykonios
  2. Friday, 30 April 2021 15:30 PM UTC
Have you tried to switch to 21.0.0.1150, and later go back to 19.2.0.2703?

Andreas.
  1. Helpful
Andreas Mykonios
  1. Andreas Mykonios
  2. Friday, 30 April 2021 15:37 PM UTC
Anyway, This thread was about the mix with reopened workspaces between 2019 and 2021.
  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.