1. Lemuel Bacli
  2. PowerServer 2020 or older (Obsolete)
  3. Tuesday, 12 January 2021 07:29 AM UTC

Hi all,

Im seeking help about this error I encountered. Since my boss requires that the application deployed on Powerserver can be accessed without vpn, I transfer it to another server. All required setting has been implemented like permissions and IIS. Now my question is, whenever Im trying to access the inetpub\wwwroot folder it always report Error 02011 even though I can open the said located using Windows Explorer.

Here is the list of users and all of them are in full control- permission

 

What else should I do in order for the Powerserver toolkit to access the remote folder?

Lemuel Bacli Accepted Answer Pending Moderation
  1. Tuesday, 12 January 2021 07:48 AM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 1

So this maybe embarrassing but  i just turn on network discovery

please close this question.

Comment
  1. Miguel Leeuwe
  2. Tuesday, 12 January 2021 12:00 PM UTC
Miguel Leeuwe

Thanks for sharing, to close it, you can mark it as resolved.
  1. Helpful
There are no comments made yet.
mike S Accepted Answer Pending Moderation
  1. Tuesday, 12 January 2021 14:35 PM UTC
  2. PowerServer 2020 or older (Obsolete)
  3. # 2

if you are transferring over via FTP, then network discovery may have opened up the windows firewall to allow ftp traffic as part of that.  That isn't of much help if you are on a public facing network rather than domain/private since you would NOT want to turn on the network discovery.

As part of the FPT setup, you must setup the firewall to allow ftp traffic.

 

 

 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.