1. John Valentin
  2. PowerBuilder
  3. Thursday, 5 August 2021 20:00 PM UTC

I have PB 2017 R3. Build 1858 (I think).

 

I modified some code in an object and set the breakpoint.

 

When I go into the debugger, the code that I modified is not there. It looks like it's an older version of the code.

I tried removing the .bak file, optimizing and then did a full rebuild but the code in the debugger is not in sync with what is in the object. 

 

What can I do?

mike S Accepted Answer Pending Moderation
  1. Thursday, 5 August 2021 20:26 PM UTC
  2. PowerBuilder
  3. # 1

you sure you don't have an overloaded function or that you aren't where you think you are (same object in more than one pbl?)

 

 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.