1. Rahul Kumar Shaw
  2. PowerBuilder
  3. Wednesday, 26 July 2017 12:29 PM UTC

I am getting datawindow error "Line 129 Column 682: incorrect syntax" error while migrating to PB2017. However the migration goes successful. Is this Ok to proceed further?

Roland Smith Accepted Answer Pending Moderation
  1. Wednesday, 26 July 2017 14:11 PM UTC
  2. PowerBuilder
  3. # 1

What version are you migrating from?

Try looking at the DataWindow in Edit Source mode. The first line with the release number is line zero as far as the error message goes. Find the line number from the message and scroll over to the column. Perhaps you could post the line of source here if you can't figure out what is wrong.

 

Comment
  1. Rahul Kumar Shaw
  2. Wednesday, 26 July 2017 14:31 PM UTC
From 12.5

  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.