1. mike S
  2. PowerServer
  3. Tuesday, 13 September 2022 17:46 PM UTC

If i use a commandparm to start powerserver client app, it will be forever sent as a commandparm.

what is going on?  how do you get rid of the commandline parm?

 

poweserver help has zero information if you search on commandparm

Tracy Huang @Appeon Accepted Answer Pending Moderation
  1. Wednesday, 14 September 2022 03:31 AM UTC
  2. PowerServer
  3. # 1

Hi Mike,

Thank you for sharing your findings. I will incorporate the following article into the user documents.

https://www.appeon.com/developers/get-help/knowledgebase/remove-stored-commandline-arguments-powerclientpowerserver-application.html

Regards

Tracy

Comment
There are no comments made yet.
mike S Accepted Answer Pending Moderation
  1. Tuesday, 13 September 2022 17:57 PM UTC
  2. PowerServer
  3. # 2

OK, poked around looking for undocumented files, and found pbapp.ini.

 

it has: 

startParam=https://myurl/myapp/ AppCommand AppCommand?f

 

this needs to be documented since it is important to how PS runs.

 

Also, how it works doesn't make any sense based on what i am seeing.

 

 

 

Comment
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.
We use cookies which are necessary for the proper functioning of our websites. We also use cookies to analyze our traffic, improve your experience and provide social media features. If you continue to use this site, you consent to our use of cookies.