1. Kirby Cemanes
  2. PowerBuilder
  3. Friday, 24 December 2021 04:16 AM UTC

Hi, I'm trying to use the embedded webbrowser but can't figure out how to catch http calls out of it. If that's at all possible.

Here's the scenario. I open up a webbrowser instance from PowerBuilder, pass in a URL, and it opens up a Javascript application. The Javascript application is a black box for us as it's provided by a third party.

At this point, I was hoping there was a way to capture http requests sent by the application running inside the webbrowser instance.

I started by looking at the available events and functions but could not find anything useful.

Does anyone have any suggestions or been through this predicament before? Thanks.

 

I'm on PowerBuilder 2019 R3 Build 2703.

Miguel Leeuwe Accepted Answer Pending Moderation
  1. Friday, 24 December 2021 17:25 PM UTC
  2. PowerBuilder
  3. # 1

Hi,

Maybe you could use WireShark to capture the requests?

regards

Comment
  1. Miguel Leeuwe
  2. Tuesday, 28 December 2021 19:04 PM UTC
I would recommend creating a support ticket on https://www.appeon.com/standardsupport/newbug so Appeon gets involved in answering your question.

regards
  1. Helpful 1
  1. Kirby Cemanes
  2. Wednesday, 29 December 2021 00:11 AM UTC
I appreciate the link. Thanks Miguel.
  1. Helpful
  1. Chris Pollach @Appeon
  2. Wednesday, 29 December 2021 00:57 AM UTC
FWIW: That would most likely be an enhancement request.
  1. Helpful
There are no comments made yet.
  • Page :
  • 1


There are no replies made for this question yet.
However, you are not allowed to reply to this question.